21344..99..44.. EExxcceeppttiioonn HHaannddlleerrOn the Switch Tools Configuration Menu, pressing "x" opens the ExceptionHandler screen as shown in Fig. 4-9-6. On this screen, you can configure theexception handling operations.Fig. 4-9-6 Exception Handler configuration screenScreen DescriptionException Handler Displays the exception handling function status.Exception HandlerModeDisplays the exception handling method.Available commands are listed below.X Enable/disable the exception handling function.Press "X." The command prompt changes to "Enable or Disable Exception Handler(E/D)>." Press "E" to enable the function. Press "D" to disable it.M Set the exception handling method.Press "M." The command prompt changes to "Select Exception Handler Mode(M/R/B)>." Press "M" to display the debug message, "R" to reboot, or "B" toexecute both.Q Return to the previous menu.PN23249K/PN23249A Local Management SystemSwitch Tools Configuration -> Exception HandlerException Handler: DisabledException Handler Mode: Debug Message-------------------------------- -----------------------------------Enable/Disable E[x]ception HandlerSet Exception Handler [M]ode[Q]uit to previous menuCommand>Enter the character in square brackets to select option
