934.7.2.d. LACP Group StatusOn the Trunk Configuration Menu, pressing "G" command and specifyingKey that has become LACP group open the LACP Group Status screen, asshown in Fig. 4-7-10. In this screen, you can confirm the status of LACPgroup. (Displaying status is possible only for key of which mode is Active orPassive.)Fig. 4-7-10 LACP Group StatusScreen DescriptionSystemPrioritySystem priority is an order of priority in this Switching Hub required forconstructing trunking on the network using LACP. Smaller number hashigher priority. The factory default setting is 1.System ID System ID is an identifier of this Switching Hub required for constructingtrunking on the network using LACP.MAC Address of this Switching Hub becomes this System ID, and it is notpossible to change this ID. Combination of System Priority value andSystem ID becomes a System ID in LACP.Key Indicates the group number of trunking.Aggregator Aggregator is a number of logical interface of trunking. This is the samenumber as the one of the port of which Priority value is the highest inthe ports that are constructing trunking.Attached PortListThis is a number of physical interface (Port) connected to logicalinterface (Aggregator). When a trunking group exceeding over 9 portswas configured, a port having a low Port Priority value gets into backupmode and is indicated as "Standby."Standby PortListWhen a trunking group exceeding over 9 ports was configured, a porthaving a low Port Priority value gets into backup mode. The relevantport is displayed in this column.PN23249K/PN23249A Local Management SystemTrunk Configuration Menu -> LACP StatusSystem Priority : 1System ID : 00:C0:8F:xx:xx:xxKey : 1Aggregator Attached Port List Standby Port List---------- -------------------------------- --------------------------------2 23 34 45 5-------------------------------- -----------------------------------[N]ext Page [P]revious Page [Q]uit to previous menuCommand>Enter the character in square brackets to select option
