151Press "S" to change the command prompt to "Enter port number e.g.: 1, 3,5-26>." Enter a port number to designate. Then, the command prompt changesto "Enable or Disable Status (E/D)>." Press "E" to enable bandwidth controlconfiguration, and press "D" to disable it.Q Return to the previous menu.44..77..88.. SSttoorrmm CCoonnttrrooll CCoonnffiigguurraattiioonn MMeennuuOn the Advanced Switch Configuration Menu, pressing "o" opens the StormControl Configuration Menu, as shown in Fig. 4-7-42. You can configure thestorm control of unknown unicast, broadcast, and multicast.Fig. 4-7-42 Storm Control ConfigurationScreen DescriptionDLF: Enables/disables the unknown unicast storm control.Enabled The unknown unicast storm control is enabled.Disabled The unknown unicast storm control is disabled. (Factorydefault setting)Broadcast: Enables/disables the broadcast storm control.Enabled The broadcast storm control is enabled.Disabled The broadcast storm control is disabled. (Factory defaultsetting)Multicast: Enables/disables the multicast storm control.Enabled The multicast storm control is enabled.Disabled The multicast storm control is disabled. (Factory defaultsetting)PN23249K/PN23249A Local Management SystemAdvanced Switch Configuration -> Storm Control Configuration MenuPort Storm Control Setting:No. DLF Broadcast Multicast Threshold---- --------- --------- --------- ---------1 Disabled Disabled Disabled 02 Disabled Disabled Disabled 03 Disabled Disabled Disabled 04 Disabled Disabled Disabled 05 Disabled Disabled Disabled 06 Disabled Disabled Disabled 07 Disabled Disabled Disabled 08 Disabled Disabled Disabled 09 Disabled Disabled Disabled 010 Disabled Disabled Disabled 0-------------------------------- -----------------------------------[N]ext Page Set [B]roadcast Status [Q]uit to previous menu[P]revious Page Set [M]ulticast StatusSet [D]LF Status Set [T]hreshold ValueCommand>Enter the character in square brackets to select option
