38Available commands are listed below.S Enable/disable the trap receiver.Press "S." The command prompt changes to "Enter manager entry number>."Enter an entry number for the trap receiver you wish to configure. Then, thecommand prompt changes to "Enable or Disable Trap Receiver (E/D)>." Press "E"to enable the SNMP manager. Press "D" to disable it.I Set an IP address for the trap receiver.Press "I." The command prompt changes to "Enter manager entry number>."Enter an entry number for the trap receiver you wish to configure. Then, thecommand prompt changes to "Enter IP address for trap receiver>." Enter the IPaddress.D Configure the trap sending settings when the link status changes.Press "D." The screen changes to the Enable/Disable Individual Trap Menu.For configuration details, refer to the next section (4.6.3.c).T Configure the trap type.Press "T." The command prompt changes to "Enter manager entry number>."Enter an entry number for the trap receiver you wish to configure. Then, thecommand prompt changes to "Enter the selection>." Press "1" to select SNMPv1traps. Press "2" to select SNMPv2 traps.C Set a community name for a trap receiver.Press "C." The command prompt changes to "Enter manager entry number>."Enter an entry number for a trap receiver you wish to configure. Then, thecommand prompt changes to "Enter community name for trap receiver>." Entera community name.Q Return to the previous menu.
