644.6.8.c Displaying MAC address table by portOn the Forwarding Database Information Menu, press "P." The commandprompt changes to "Enter Port Number>." Specifying a port number opensthe Display MAC Address by Port screen as shown in Fig. 4-6-19. In thisscreen, you can display MAC address table by port.Fig. 4-6-19 Displaying MAC address table by portScreen DescriptionAge-Out Time: Displays a time to store MAC address table. It is equal to the time afterreceiving the last packet. The factory default setting is 300 seconds (5minutes).Select Port: Displays the selected port number.MAC Address Displays a MAC address in MAC address table.Port Displays a port to which the MAC address has belonged.Available commands are listed below.N Display the next page.Press "N" to display the next port.P Display the previous page.Press "P" to display the previous port.A Set a time to store MAC address.Press "A." The command prompt changes to "Enter Age-Out time>." Enter Age-Outtime with a value of 10 to 1000000 by seconds.S Switch a port to be displayed.Press "S." The command prompt changes to "Enter Port Number>." Enter a portnumber you wish to display.Q Return to the previous menu.PN23249K/PN23249A Local Management SystemForwarding Database Menu -> Display MAC Address by PortAge-Out Time: 300 Sec. Selected Port: 1MAC Address Port----------------- ------------------------------------ -----------------------------------[N]ext Page [S]elect Port No[P]revious Page [Q]uit to previous menuSet [A]ge-Out TimeCommand>Enter the character in square brackets to select option
