884.7.2.b. Trunk ConfigurationOn the Advanced Switch Configuration Menu, pressing "L" opens the TrunkConfiguration Menu screen, as shown in Fig. 4-7-8. In this screen, you canconfigure trunking.Fig. 4-7-8 Trunk ConfigurationScreen DescriptionSystemPrioritySystem priority is an order of priority in this Switching Hub required forconstructing trunking on the network using LACP. Smaller number hashigher priority. The factory default setting is 1.Key Indicates the group number of trunking.Mode Indicates the operation mode of trunking.Active Sends out LACP packet from this Switching Hub andconstructs a trunk by negotiating with other side.It is required that the other side mode is Active orPassive.Passive Does not send out LACP packet from this SwitchingHub and constructs a trunk by negotiating with otherside using LACP packet received from other side.It is required that the other side mode is Active.Manual Constructs trunking forcibly without using LACPpacket. It is required that the other side is the sameconfiguration as this side.Members PortListIndicates the port belonging to trunking group.PN23249K/PN23249A Local Management SystemAdvanced Switch Configuration -> Trunk Configuration MenuSystem Priority : 1Key Mode Member Port List----- -------- ----------------------------------------------------------------------------------------------- -----------------------------------[N]ext Page [A]dd Group Member Set P[o]rt Priority[P]revious Page [R]emove Group Member LACP [G]roup StatusSe[t] System Priority [M]odify Group Mode [Q]uit to previous menuCommand>Enter the character in square brackets to select option
