1554.7.9.a. IEEE 802.1X Port Based Access ControlConfigurationOn the 802.1X Access Control Configuration Menu screen, pressing "p"opens the Port Based Access control Configuration Menu as shown in Fig.4-7-44. On this screen, you can configure the IEEE 802.1X port based accesscontrol.The supported authentication methods are EAP-MD5, TLS, and PEAP.Fig. 4-7-44 IEEE 802.1X Port Based Access Control ConfigurationScreen DescriptionNAS ID Displays the access ID (NAS Identifier).Port No Displays the port number.Port Control Displays the operation mode for authentication requests.Auto The access control function is enabled. Theauthentication process relay is performedbetween the client and authentication server.ForceUnauthorizedThe access control function is disabled. Allauthentication requests from clients are ignored.Force Authorized The access control function is disabled. The port ismade accessible without authentication. (Factorydefault setting)Port Status Displays the authentication status. reflecting the Port Control settingshown below.Unauthorized Indicates that the ID is not authorized.Authorized Indicates that the ID is authorized.PN23249K/PN23249A Local Management SystemAdvanced Switch Configuration -> Port Based Access Control Configuration MenuNAS ID: Nas1 Port No: 1 Port Control : Force AuthorizedPort Status : Authorized Authorized MAC Address: --:--:--:--:--:--Operational Control Direction : BothAdministrative Control Direction: BothPer Port Re-auth : DisabledCurrent PVID : 1 Dynamic VLAN : DisabledGuest Access Mode : BothTransmit Period : 30 seconds Max Request : 2Supplicant Timeout : 30 seconds Quiet Period : 60 secondsServ Timeout : 30 seconds Re-auth Period : 3600 secondsGuest VLAN ID : ---- Default VLAN ID : ------------------------------------ -----------------------------------[N]ext Page [T]ransmission Period R[e]-auth PeriodPre[v]ious Page Q[u]iet Period Re-[a]uth Status[P]ort No Ma[x]imum Request Initiali[z]ePort Auth [M]ode Server Time[o]ut [R]e-auth InitializePort [C]ontrol Supp[l]icant Timeout Delete Aut[h] MACPort Ctrl [D]irection Gue[s]t Access Mode Force Auth MAC T[i]meoutNum[b]er of Supplicant [G]uest VLAN ID [Q]uit to previous menuDe[f]ault VLAN ID D[y]namic VLAN StatusCommand>Enter the character in square brackets to select option
