3044..66..11.. SSyysstteemm AAddmmiinniissttrraattiioonn CCoonnffiigguurraattiioonnOn the Basic Switch Configuration Menu, pressing "A" opens the SystemAdministration Configuration Menu, as shown in Fig. 4-6-2. On this screen,you can set administrative information, such as device name.Fig. 4-6-2 System Administration ConfigurationScreen DescriptionDescription: Displays the system information. This item is not editable.Object ID: Displays the ID, corresponding to MIB. This item is not editable.Name: Displays the system name. The factory default setting is blank.Location: Displays the device installation location. The factory default setting isblank.Contact: Displays the contact information. The factory default setting is blank.Available commands are listed below.N Set/edit the system name.Press "N." The command prompt changes to "Enter system name>." Enter aSwitching Hub name in 50 characters or less.L Set/edit the device installation location information.Press "L." The command prompt changes to "Enter system location>." Enter aSwitching Hub location in 50 characters or less.C Set/edit the contact information.Press "C." The command prompt changes to "Enter system contact>." Entercontact information in 50 characters or less.Q Return to the previous menu.PN23249K/PN23249A Local Management SystemBasic Switch Configuration -> System Admin. Configuration MenuDescription: Switch-M24PWRObject ID: 1.3.6.1.4.1.396.5.4.1.19Name:Location:Contact:-------------------------------- -----------------------------------Set System [N]ameSet System [L]ocationSet System [C]ontact Information[Q]uit to previous menuCommand>Enter the character in square brackets to select option
