584.6.7.a. Report Data ConfigurationOn the Mail Report Configuration Menu, pressing "C" opens the ReportData Configuration screen, as shown in Fig. 4-6-15. In this screen, you canset content to be described in a report.Fig. 4-6-15 Report Data ConfigurationScreen DescriptionReport Interval Indicates a reporting interval.Sample Interval Indicates an interval to obtain samples.Port Info Indicates whether a port status is set as an object of notification ornot.Traffic Info Indicates whether a traffic information is set as an object ofnotification or not.System Log Indicates whether a system logis set as an object of notification ornot.Attach File Indicates whether to attach a content of notification to report mailor not.Attached File Type Indicates a type of attached file.Attached Ports Indicates a port number for the report.Utilization Indicates whether a utilization rate is set as an object of notificationor not.Total Frames Indicates whether a total number of frames is set as an object ofnotification or not.Broadcasts Indicates whether the number of broadcasts is set as an object ofnotification or not.Multicasts Indicates whether the number of multicasts is set as an object ofnotification or not.PN23249K/PN23249A Local Management SystemMail Report Configuration Menu -> Report Data Configuration MenuReport Interval: Daily Utilization: DetachedSample Interval: 10 Minutes Total Frames: AttachedPort Info: Enabled Broadcasts: AttachedTraffic Info: Enabled Mulitcasts: AttachedSystem Log: Enabled Collisions: AttachedAttach File: Enabled Errors: AttachedAttached File Type: csvAttached Ports:-------------------------------- -----------------------------------Set [R]eport Interval [A]dd Attached PortsSet [S]ample Interval [D]elete Attached PortsEnable/Disable [P]ort Info Attach/Detach [U]tilizationEnable/Disable [T]raffic Attach/Detach T[o]tal FramesEnable/Disable System [L]og Attach/Detach [B]roadcastsEnable/Disable Attach [F]ile Attach/Detach [M]ulticastsSet Attached File T[y]pe Attach/Detach [C]ollisions[Q]uit to previous menu Attach/Detach [E]rrorsCommand>Enter the character in square brackets to select option
