40Available commands are listed below.A Enable/disable the trap sending when the link status changes.Press "A." The command prompt changes to "Enable or Disable SNMPAuthentication trap (E/D)>." Press "E" to enable the trap sending. Press "D" todisable it.P Add a port to which the trap is sent when its link status changes.Press "P." The command prompt changes to "Enter port number>." Enter a portnumber. The trap is sent for this port.D Delete a port to which the trap is sent when its link status changes.Press "D." The command prompt changes to "Enter port number>." Enter a portnumber. The trap is not sent for this port.E Enable/disable the trap sending when the power usage percentage exceeds thePower Usage Threshold For Sending Trap, as set on the PoE Global ConfigurationMenu.Press "E." The command prompt changes to "Enable or Disable PoE trap (E/D)>."Press "E" to enable the trap sending. Press "D" to disable it.T Enable/disable the trap sending when the internal temperature exceeds the presettemperature.Press "T." The command prompt changes to "Enable or Disable Temperature trap(E/D)>." Press "E" to enable the trap sending. Press "D" to disable it.S Set a temperature threshold value to send the trap for a high device internaltemperature.Press "S." The command prompt changes to "Enter temperature threshold>." Entera temperature threshold value in the range from 0 to 50 degress C to send thetrap.F Enable/Disable the trap sending when the internal fan fails.Press "E." The command prompt changes to "Enable or Disable Fan Failure trap(E/D)>." Press "E" to enable the trap sending. Press "D" to disable it.Q Return to the previous menu.
