1804.7.10.a. Set Leave Mode MenuOn the IGMP Snooping Configuration Menu, pressing "L" opens the SetLeave Mode Menu as shown in Fig. 4-7-54. On this screen, you can set theoperation after receiving a Leave packet.Fig. 4-7-54 Set Leave Mode MenuScreen DescriptionLeave Delay Time Displays the waiting time after receiving a Leave packet.Port Displays the port number.Mode Displays the operation after receiving a Leave packet.Available commands are listed below.N Show the next page.Press "N." The screen displays the next page.P Show the previous page.Press "P." The screen displays the previous page.S Set the operation after receiving a Leave packet.Press "S." The command prompt changes to "Select port number to be changed>."Enter the port number you wish to configure. Then, the command promptchanges to "Set leave mode (N/I)>." Press "I" to send a Leave packet to the routerport immediately after receiving it. Press "N" to wait for the specified Leave DelayTime before sending it to the router port.T Set the waiting time after receiving a Leave packet.Press "T." The command prompt changes to "Set leave delay time>." Set the timeto wait after receiving a Leave packet in seconds between 1 and 10. (Factorydefault setting is 5 seconds.)PN23249K/PN23249A Local Management SystemIGMP Snooping Configuration -> Set Leave Mode MenuLeave Delay Time : 5 secPort Mode------ ------------1 Normal2 Normal3 Normal4 Normal5 Normal6 Normal7 Normal8 Normal9 Normal10 Normal-------------------------------- -----------------------------------[N]ext Page [P]revious Page [Q]uit to previous menu[S]et Leave Mode Set Leave Delay [T]imeCommand>Enter the character in square brackets to select option
