914.7.2.c. Set Port Priority for LACPOn the Trunk Configuration Menu, pressing "o" opens the Set Port Priorityscreen, as shown in Fig. 4-7-9. In this screen, you can set priority value oftrunking.Fig. 4-7-9 Set Port PriorityScreen DescriptionSystemPrioritySystem priority is an order of priority in this Switching Hub required forconstructing trunking on the network using LACP. Smaller number hashigher priority. The factory default setting is 1.System ID System ID is an identifier of this Switching Hub required for constructingtrunking on the network using LACP.MAC Address of this Switching Hub becomes this System ID, and it is notpossible to change this ID. Combination of System Priority value andSystem ID becomes a System ID in LACP.Port This is a port number of this Switching Hub.Priority This is a priority order of this Switching Hub by port in trunking. Smallernumber has higher priority. It is effective when trunking group having 9or more ports was configured. The factory default settings for each portare 1.Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.S Set a Priority value (priority order) by port.PN23249K/PN23249A Local Management SystemTrunk Configuration Menu -> Set Port PrioritySystem Priority : 1System ID : 00:C0:8F:xx:xx:xxPort Priority----- ----------1 12 13 14 15 16 17 18 19 110 1-------------------------------- -----------------------------------[N]ext Page [S]et Port Priority[P]revious Page [Q]uit to previous menuCommand>Enter the character in square brackets to select option
