20644..99..11.. TTFFTTPP SSooffttwwaarree UUppggrraaddeeOn the Switch Tools Configuration Menu, pressing "T" opens the TFTPSoftware Upgrade screen as shown in Fig. 4-9-2. On this screen, you canexecute and configure firmware upgrades.Fig. 4-9-2 TFTP Software UpgradeScreen DescriptionImage Version Displays the current firmware version.TFTP Server IP Displays the IP address of the TFTP server with the firmware to beupgraded installed.Image FileNameDisplays the file name of the firmware to be upgraded.Reboot Timer Displays the time before rebooting after downloading the firmware.You can set the time in the System Reboot Menu.Available commands are listed below.S Set the IP address of the TFTP server with the firmware to be upgraded installed.Press "S." The command prompt changes to "Enter IP address of TFTP server>."Enter the IP address of the TFTP server.F Set the file name of the firmware to be upgraded.Press "F." The command prompt changes to "Enter file name>." Specify the filename of the downloaded program in 30 characters or less.U Start the upgrade.Press "D." The command prompt changes to "Download file(Y/N)>." Confirmwhether or not you wish to start the process. Confirm that all settings arecorrect. Press "Y" to start the upgrade. If you find any incorrect setting, press"N" to reset the settings.PN23249K/PN23249A Local Management SystemSwitch Tools Configuration -> TFTP Software UpgradeImage Version: 2.0.0.xxTFTP Server IP: 0.0.0.0Image File Name:Reboot Timer: 0 seconds(Please set timer value at Reboot Menu)-------------------------------- -----------------------------------Set TFTP [S]erver IP AddressSet Image [F]ile Name[U]pgrade Image[Q]uit to previous menuCommand>Enter the character in square brackets to select option
