90Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.T Set System Priority value of this Switching Hub in LACP.Press "T." The command prompt changes to "Enter system priority for LACP >."A Configure new trunking settings.Press "A." The command prompt changes to "Enter trunk group admin key>."Enter a group number you wish to configure. The command prompt changes to"Enter port member for group key #>." Enter a port number you wish to dotrunking. When entering multiple port numbers, delimit with comma (,) with nospace (example: "1,2,3"), or hyphenate the continuous numbers (example: "8-12").Then, the command prompt changes to "LACP Active, LACP Passive or Manualtrunk setting(A/P/M)>." Enter "A" to make operation mode Active, or "P" to makeit Passive, or "M" to make it Manual, respectively.R Remove trunking settings.Press "R." The command prompt changes to "Enter trunk group admin key>." Entera group number you wish to delete. The command prompt changes to "Enter portmember port for group key #>." Enter a port number you wish to do rdelete.When entering multiple port numbers, delimit with comma with no space, orhyphenate the continuous numbers.M Modify the operation mode of trunking.Press "M." The command prompt changes to "Enter trunk group admin key>."Enter a group number you wish to modify. Then, the command prompt changesto "LACP Active, LACP Passive or Manual trunk setting(A/P/M)>." Enter "A" tomake operation mode Active, or "P" to make it Passive, or "M" to make it Manual,respectively.O Set System Priority value of this Switching Hub by port in trunking.Press "o" to open the "Set port Priority" screen. For method of detail setting, referto the section (4.7.2.c).G Display a status of LACP group.Press "G." The command prompt changes to "Enter trunk group number >." Enter akey of group you wish to display. (Only the group of which mode is Active orPassive can be entered.) Then, screen changes to "LACP Status." For details, referto the section (4.7.2.d).Q Return to the previous menu.Note: In this Switching Hub, it is possible to set members of up to 24 portsto one group, but it is up to 8 ports that execute trunking operation.Members after the 9th port in that group get into backup mode.When a failure occurred in link of 1–8 port, one of them becomes amember that constructs trunk on behalf of that port. In this case,priority order to become a member is determined by Port Prioritythat is set in next section (4.7.2.c), and, when Priority value is thesame to all, trunk is constructed by a member starting from thesmallest port number in order.
