3144..66..22.. SSyysstteemm IIPP AAddddrreessss CCoonnffiigguurraattiioonnOn the Basic Switch Configuration Menu, pressing "I" opens the System IPConfiguration Menu, as shown in Fig. 4-6-3. On this screen, you can setIP-address-related settings for this Switching Hub.Fig. 4-6-3 System IP ConfigurationScreen DescriptionMACAddress:Displays the MAC address of this Switching Hub. This value is uniquelyassigned to each device and cannot be changed.IP Address: Displays the current IP address. 0.0.0.0 is factory default setting.SubnetMask:Displays the current subnet mask. 0.0.0.0 is factory default setting.DefaultGateway:Displays the IP address of the router, set as a current default gateway.0.0.0.0 is factory default setting.DHCP Mode: Displays the DHCP mode. If enabled, the Switching Hub requests an IPaddress to the DHCP server. 'Disabled' is the factory default setting.Enabled: Requests an IP address from the DHCP server whenstarting up.Disabled: Does not request an IP address from the DHCP server whenstarting up.DHCPRenewRenews an IP address from the DHCP server.PN23249K/PN23249A Local Management SystemBasic Switch Configuration -> System IP Configuration MenuMAC Address: 00:C0:8F:xx:xx:xxIP Address: 0.0.0.0Subnet Mask: 0.0.0.0Default Gateway: 0.0.0.0DHCP Mode: Disabled-------------------------------- -----------------------------------Set [I]P AddressSet Subnet [M]askSet Default [G]atewaySet IP P[a]rameterSet [D]HCP StatusSet DHCP [R]enew[Q]uit to previous menuCommand>Enter the character in square brackets to select option
