185Available commands are listed below.E Configure the IGMP Snooping Querier function.If you press "E," the command prompt changes to "Enable or Disable querierstatus (E/D)>." Press "E" to enable the function. Press "D" to disable it.V Set the version of IGMP queries to be sent.If you press "V," the command prompt changes to "Enter IGMP version (1/2)>."Press "1" to use Version 1. Press "2" to use Version 2.I Set the IGMP query sending interval.Press "I." The command prompt changes to "Enter query interval >." Enter avalue between 1 and 18000 (seconds).M Set the IGMP query response waiting time.Press "M." The command prompt changes to "Enter max response time >."Enter a value between 1 and 25 (seconds).T Set the time before determining that there is no longer another Querier.Press "T." The command prompt changes to "Enter querier timeout >." Enter avalue between 60 and 600 (seconds).C Set the number of queries sent when an STP topology change is made.Press "C." The command prompt changes to "Enter TCN query count >." Enter avalue between 1 and 10 (the number of times).N Set the interval of sending queries when an STP topology change is made.Press "N." The command prompt changes to "Enter TCN query interval >." Entera value between 1 and 10 (seconds).Q Return to the previous menu.
