179Available commands are listed below.N Show the next page.Press "N." The screen displays the next page.P Show the previous page.Press "P." The screen displays the previous page.G Enable IGMP Snooping.Press "G." The command prompt changes to "Enable or Disable IGMP snooping(E/D)>." Press "E" to enable the function. Press "D" to disable it.U Enable multicast filtering.Press "U." The command prompt changes to "Enable or Disable MulticastFiltering (E/D)>." Press "E" to enable the function. Press "D" to disable it.C Set IGMP snooping Querier.Press "C." The Set Querier Configuration Menu opens. (Refer to 4.7.10.d.)H Set the aging time of multicast group members.Press "S." The command prompt changes to "Enter age out time>." Set the timebetween 150 and 300 seconds.R Set the aging time of the multicast group's router port.Press "S." The command prompt changes to "Enter age out time>." Set the timebetween 150 and 300 seconds.I Set the Proxy Report waiting time.Press "I." The command prompt changes to "Enter forward interval>." Set thetime between 0 and 25 seconds.L Set the operation after receiving a Leave packet.Press "L." The Set Leave Mode Menu opens. (Refer to 4.7.10.a.)V Set a VLAN to be filtered.Press "V." The Show IGMP Snooping VLAN Filter Table Menu opens.(Refer to 4.7.10.b.)T Show router ports.Press "T." The Show Router Port Table Menu opens.(Refer to 4.7.10.c.)M Statically set a router port.Press "M." The command prompt changes to "Add or Delete static groupmember(A/D)>." Press "A" to add a router port. Press "D" to delete it. Then,enter the target VLAN ID, multicast MAC address, and port number.Q Return to the previous menu.Note: The IGMP Snooping function and the Internet Mansion mode cannotbe used simultaneously.
