964-6-4 Marking trigger input: Continuous trigger Without “allow to stop halfway” settingWhen the trigger mode is set to “continuous trigger” in the file settings, lasing operation is repeated while TRIGGER IN(X5) is on. Without “allow to stop halfway” setting if TRIGGER IN turns OFF when the lasing operation is running, the lasingoperation is terminated after finishing the running operation.*2*1*1T5T2T4T3T3T7T6T2T1READY OUT (Y5)TRIGGER IN (X5)PROCESSING OUT(Y10)PROCESSING ENDOUT (Y11)PROCESSING FAILOUT (Y12)WARNING OUT (Y14)ALARM OUT (Y15)ONOFFONOFFONOFFONOFFONOFFON (Normal)OFF (Error)ON (Normal)OFF (Error)ONOFFMarkinginterruptionLASING OUT (Y20)*1 : If TRIGGER IN (X5) is still ON at the completion of the lasing operation, the lasing operation starts again.*2 : If TRIGGER IN (X5) turns OFF when the lasing operation is running, the lasing operation is terminated after finishingthe running operation.Item Time RemarksT1 2 ms or more Keep the ON status for the duration of repeating the lasing operation.T2 0 to 9999 ms When the trigger delay time is set in the selected file, trigger processing (lasing) operationstarts after the delay time.T3 0.0 to 60.0 sec. When the scanning interval is set, the next lasing operation starts after a lapse of thesetting period.T4 2 to 510 ms This is the output to notify that the marking trigger processing completed normally. Thisis One-shot output. Set the output time on the system settings screen. There is a smallmargin of error for the setting value.T5 Approx. 3 sec. It outputs a warning to notify that an invalid trigger was input when TRIGGER IN (X5) wasinput during trigger processing. This is One-shot output. You can turn this warning off bythe settings.T6 ― Time for marking data creation. It varies depending on the quantity of the setting data. Thistime is required at every marking.T7 2 to 510ms If the trigger processing was stopped by an alarm or a warning, PROCESSING FAIL OUT(Y12) turns on during the one-shot output period. PROCESSING END OUT (Y11) will notbe output at this time.ME-LPGS-SM-8
