954-6-3 Marking trigger input: Single triggerWhen the trigger mode is set to “single trigger” in the file settings, one lasing operation is executed by the edge of turningon of TRIGGER IN (X5).ONOFFONOFFONOFFONOFFONOFFONOFFON (Normal)OFF (Error)ON (Normal)OFF (Error)T1T5T4T2T1T4T6T2T1T3 T3 T3READY OUT (Y5)TRIGGER IN (X5)PROCESSING FAILOUT (Y12)WARNING OUT (Y14)ALARM OUT (Y15)PROCESSING OUT(Y10)PROCESSING ENDOUT (Y11)MarkinginterruptionMarkinginterruptionLASING OUT (Y20)Item Time RemarksT1 2ms or more Keep the ON status for 2ms or more.T2 ― When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON. The output timeof PROCESSING OUT (Y10) includes the trigger delay time, marking preparation time,laser radiation time, and processing time after marking has completed.If you are not using the link function with external devices, output time of PROCESSINGOUT (Y10) is almost the same as the total duration of the trigger delay time and LASINGOUT (Y20).T3 0 to 9999ms When the trigger delay time is set in the selected file, trigger processing (lasing) operationstarts after the delay time.T4 2 to 510ms This is the output to notify that the marking trigger processing completed normally. Thisis One-shot output. Set the output time on the system settings screen. There is a smallmargin of error for the setting value.T5 Approx. 3 sec. It outputs a warning to notify that an invalid trigger was input when TRIGGER IN (X5) wasinput during trigger processing. This is One-shot output. You can turn this warning off bythe settings.T6 2 to 510ms If the trigger processing was stopped by an alarm or a warning, PROCESSING FAIL OUT(Y12) turns on during the one-shot output period. PROCESSING END OUT (Y11) will notbe output at this time.ME-LPGS-SM-8
