1256-1-6 Image checker settingSettings to use the image checker PV230/PV200 for link control with the laser marker are described below.ンㄆㄇㄆㄓㄆㄏㄆ• For specifications and setting of image checker PV230/PV200, refer to the instruction manual for PV230/PV200. Communication settings of image checker PV230/PV200To connect the laser marker with PV230/PV200, configure the PV230/PV200's communication settings as follows.Item Ethernet communication specificationsCommunication protocol Multipurpose communication (TCP/IP)Port No.(Fixed)Result output 8601Command transmission 8604IP address Initial value: 192.168.1.5Make sure that the IP address for the laser marker on the network is not overlapping the IPaddress for the other external devices. Input/output settingTo use the link control function with the laser marker and PV230/PV200, configure the system settings on the PV230/PV200 as follows.1. From “Environment” - “Input/Output” setting screen of PV230/PV200, select the “General Output”.2. Set the items of Ethernet with the protocol setting“General Com.” as follows.• Output: Yes• Operation: Synchronized• Date/Time: No• Scan Count: No• Total Judge: Yes• Judge: No *• Numeric CalculationFor position correction : YesFor other than position correction : No *• Optical Character Recognition: No *• Code Reader: No *• BCC: No• Number of Digits: 7• Decimal Digit: 3• Unused Digit: Fill with 0• Error Output: No ** : When you use Ethernet with the protocol setting both “PLC Com.” and “General Com.”, for the items with * you canchange the settings according to your PLC configuration. For the items without *, follow the above settings.ンㄆㄇㄆㄓㄆㄏㄆ• When the result of the total judgement by PV230/PV200 is “1”, the laser marker outputs CHECK OK OUT, and when theresult is “0”, CHECK NG OUT is output.ME-LPGS-SM-8
