372-3-2 Installation method• Install the head on a plate with a thickness of 10 mm to 15 mm or more which is made of aluminum or other material withradiation performance equivalent to that of aluminum.• For details of installation, refer to “1-5-1 Head” (P.24).• Fix the head in the following conditions.Fixing surface Fixing screw Screw insert length Tightening torqueBottom (laser emission port side) M6 screws at 5 positions 5 mm to 6 mm 3.0 N·m or belowSide (right/left) M6 screws at 4 positions on each side 10 mm to 11 mm 3.0 N·m or belowM6 screwABM6 screwA : Screw insert length 5mm to 6mm forbottom, 10mm to 11mm for sidesB : Plate thickness + washer thicknessLaser marker headInstallation plateワㄐㄕㄊㄆ• Do not insert any screw of length exceeding the specification. Otherwise, the failure of the product may be caused. Example of head installation baseExample dimensions of plate for the head are indicated below.For plate thickness of 10 mmUnit: mm120 φ2060 10 5qer4060120 60wφ94 On the laser marker sideNo. Descriptionq Head fixing hole (five holes): φ6.6 through holew Head positioning pin (2 pins): φ4 SUS pin, height 5e LP-GS051 / LP-GS051-L: 77.5 mm, LP-GS052: 69.5 mmr LP-GS051 / LP-GS051-L: 27 mm, LP-GS052: 24 mmンㄆㄇㄆㄓㄆㄏㄆ• As the laser pointer radiate the beam toward the center of the marking field, it is recommended to process the laseremission port and laser pointer emission port hole to link them so that the laser pointer's beam path does not interferewith the plate.ME-LPGS-SM-8
