673-4-4 Remote mode settingsTo control the laser marker externally using I/O or serial communication commands, set the operation mode to the remotemode with one of the following methods.Select the method to switch to the remote mode on the system settings screen of Laser Marker NAVI smart. Refer to “3-4-3Settings before external control” (P.64).Remote mode switching by Laser Marker NAVI smartClick the “Laser Marker Operation” tool of Laser Marker NAVI smart. Then, click“Remote mode ON/OFF”. Click “Yes” on the confirmation screen to switch thelaser marker to the remote mode.ンㄆㄇㄆㄓㄆㄏㄆ• The “Remote mode ON/OFF” button is available when the following screens areselected with the online connection established.• Marking settings screen• Operator settings (restricted) screen• Monitor screenStartup the laser marker in the remote mode (Laser Marker NAVI smart can switch the remote mode)When you turn ON the key switch of the laser marker, the system starts in the remote mode. Use the remote modeswitch button of Laser Marker NAVI smart for releasing and resetting the remote mode.ンㄆㄇㄆㄓㄆㄏㄆ• If you want to start up the laser marker in the remote mode, you need to configure the settings on the system settingsscreen of Laser Marker NAVI smart in advance.• If you have configured the laser marker to start up in the remote mode, you cannot switch the remote mode from I/O.Remote mode switching using I/OTurn ON REMOTE IN (X4) of the I/O terminal block on thecontroller.ンㄆㄇㄆㄓㄆㄏㄆ• To enable switching to the remote mode by REMOTE IN (X4) on the I/O terminal block, you need to configure thesettings on the system settings screen of Laser Marker NAVI smart in advance.• If you have configured the remote mode switching method to the I/O terminal block, you cannot switch the remote modefrom the Laser Marker NAVI smart screen.WARNING • If the laser marker is set to enter the remote mode at startup or by I/O control,construct a manual resetting system to re-pump the laser when the laserpumping is turned to off due to an emergency stop or an interlock.REMOTE INX1X2X3X4X5X6X7Y1Y2Y3Y4Y5Y6Y7PLC, etc.OUTPUTI/O terminal blockME-LPGS-SM-8
