392-3-4 Marking position check Guide laserThe marking position can be checked visually by using the guide function with the red laser beam.ワㄐㄕㄊㄆ• Use the guide display function only as the guideline. For the appropriate marking quality, fine adjust the work distanceand setting position of the target object by checking the actual marking results.With the guide laser the following data can be indicated.Display mode DescriptionGuide pointer The red point emitted in oblique indicates the center of the marking field when the work distanceis set to the specified reference position.When the work distance is set out of the specified base position or Z-position value is other than0mm, guide pointer does not indicate the center of the marking field and you cannot use it as areference.Marking field *1 Displays the marking field frame and center lines with the guide laser.Marking image *1 Displays the setting data in the file.The object data with marking off setting is not displayed.Masked objects *1 Displays only the data set to Marking off and enabled guide indication.Work distance *1 The guide laser shows the rough indication of the work distance (distance from the head base tothe marking surface). The red point emitted in oblique and the red cross emitted perpendicularlyfrom the head are displayed. The distance where the laser point is closest to the center of thecross represents the guide of the work distance.*1 : Available only to LP-GS051(-L) type.Guide pointer Work distance indication *1 Marking image indication *1Marking field indication *1Where the red point is closest tothe center of the cross is the roughindication of the work distance.ンㄆㄇㄆㄓㄆㄏㄆ• For details of the guide display function, please refer to the Laser Marker NAVI smart Operation Manual.• For LP-GS052 type, only the guide pointer function is available.ME-LPGS-SM-8
