332-1 Installation EnvironmentUse this product in the following environments.Item Installation environment conditionsOperating ambient temperature *1 0°C to +40°COperating ambient humidity *1 35 to 85%RHAmbient temperature for storage *1 -10°C to +60°C *2Vibration resistance Head (with/without current): Acceleration of 9.8 m/s2 or belowController (without current): Acceleration of 9.8 m/s2 or belowPollution degree 2Use location Indoor; at an altitude of 1000 m or below*1 : No condensation or freezing shall be allowed.*2 : If there is a gap between the stored temperature and operating temperature, make sure to have the product get usedto the operating ambient temperature gradually prior to use to prevent the dew condensation.ワㄐㄕㄊㄆ• Do not install this product at a place where vibrations and shocks can be directly transmitted to it.• Do not use this product at a place with oil mist.• In case this product is used in a dusty environment, take measures to prevent dust from entering into the laser marker, e.g.using a storage housing.• When installing the laser marker in the storage housing, use a housing equipped with panel cooler or heat exchanger tomaintain the air-cooling performance of the laser marker according to the ambient temperature.Panel cooler orheat exchangerPanel cooler orheat exchangerStorage housing image• Remove any dust and smoke from the laser emission port and laser beam path using a dust collector. For effective dustcollection, put the suction port of the dust collector near the lasing position. In an environment where dust and smokethat tend to attach to the lens surface, it is recommended to create a compression air flow to ensure thorough dust collection.ABCABCDABCompressedairDust collectorLaser marker headME-LPGS-SM-8
