1135-3-2 Communication settingsItem Ethernet communication settingsCommunication protocol TCP/IPStandards IEEE802.3 (10BASE-T) / IEEE802.3u (100BASE-TX)Applicable cable Category 5 or higherApplicable HUB (or rooter) 10BASE-T / 100BASE-TX compatibleIP address 1.0.0.0 to 223.255.255.255 * (Initial value: 192.168.1.5)Subnet mask 128.0.0.0 to 255.255.255.254 (Initial value: 255.255.255.0)Default gateway 1.0.0.0 to 223.255.255.255 * (Initial value: 0.0.0.0 (Unspecified))PC configuration software port 1025 to 65534, except 9090 (Initial value: 9093)Command communication port 1025 to 65534, except 9090 (Initial value: 9094)* Do not use “127” in the first octet.ンㄆㄇㄆㄓㄆㄏㄆ• The communication control of the laser marker through the Ethernet should be performed in a secure network settings.• Even the IP Address and Subnet Mask values are within the configurable range, they may not be available dependingon the combination.• For the details of the communication settings, refer to “3-4-3 Settings before external control” (P.64).⿎ Ethernet communication settings for communication command controlItem Ethernet communication settingsStart code * ON (STX) / OFF (initial setting: STX)Response data command * ON / OFF (initial setting: ON)Response data subcommand *Any single byte character of ASCII code from 01 (HEX) to 7F (HEX) can be specified.• Initial setting of positive response code: A• Initial setting of negative response code: E• Initial setting of read request response code: ACharacter code ASCII codeEncoding for 2-bytecharacters *Shift-JIS / GB 2312 (initial setting: Shift-JIS)Check sum OFFEnd code CRReception timer Timeout monitoring ON (10 sec.)* If you set “LP-400/V compatibility” in the system settings of Laser Marker NAVI smart, the same command formatwith the former models of LP-400/LP-V series is applied regardless these settings. For the details, refer to the “SerialCommunication Command Guide: LP-400/V compatible mode”.ME-LPGS-SM-8
