Panasonic LP-GS Series Setup & Maintenance Manual

Also see for LP-GS Series: Serial Communication Command Guide Serial Communication Command Guide Quick reference Operation manual

Contents

Panasonic LP-GS Series Setup & Maintenance Manual Manual pdf 112 page image

1125-3 Ethernet5-3-1 Port specifications and connectionTo control the laser marker by Ethernet communication, use an Ethernet port on the controller.ンㄆㄇㄆㄓㄆㄏ㄄ㄆ• The Ethernet port of this product is compatible with both straight cable and cross cable.• Although the maximum length of cables connecting devices permitted by the standards of Ethernet is 100 m, in order toprevent communication failure due to noise or breakdown of the device, it is recommended to keep the length to 10 m orless.• The Ethernet port can be connected with the following devices simultaneously via a HUB or a router.• PC configuration software• External device for communication command control (PLC and PC for control)• Specific image checkerRear of controllerOn the laser marker controller sideRJ-45 8-pole connectorAUTO-MDIX compatibleOrange LEDGreen LEDLight up color DescriptionGreen The indicator lights up while connected normally. It blinks during communication.Orange Lights up only when the baud rate is 100 megabits/sec.⿎ LAN cable connectionWhen you connect a LAN cable to the Ethernet port, attach the ferrite core included to a position as close as possible tothe Ethernet port on the LAN cable controller side.If the ferrite core diameter is too large for the cable width, fix the ferrite core using a tie band.Ferrite coreLAN cableTie bandLaser marker controllerME-LPGS-SM-8