944-6-2 Shutter open/closeON (Open)OFF (Close)ON (Open)OFF (Close)ON (Open)OFF (Close)ON (Open)OFF (Close)ONOFFONOFFONOFFONOFFONOFFT3*1 *2T1 T1T1 T1T1T1T2 T2 T2T5T4LASER STANDBY OUT (Y6)TRIGGER IN (X5)READY OUT (Y5)PROCESSING OUT (Y10)PROCESSING END OUT (Y11)SHUTTER ENABLE IN (X9)SHUTTER IN (X8)SHUTTER OPEN 1 OUT (Y8)SHUTTER OPEN 2 OUT (Y9)*1 : SHUTTER IN (X8) is accepted and the shutter opens only when SHUTTER ENABLE IN (X9) is turned on.*2 : If SHUTTER IN (X8) was turned off during the trigger processing, the shutter closes after the trigger processing hascompleted.Item Time RemarksT1 Max. 1 sec. There is a delay time of around 200ms to max. 1 second from turning ON/OFF ofSHUTTER IN (X8) to turning ON/OFF of SHUTTER OPEN 1 OUT (Y8) and SHUTTEROPEN 2 OUT (Y9).SHUTTER OPEN 1 OUT and SHUTTER OPEN 2 OUT will be output by the sameoperation, but their output timing has a margin of error.T2 ― Total time for shutter opening (T1) and marking data creation. It varies depending on thequantity of the setting data.T3 2ms or more Keep the ON status for 2ms or more.T4 ― When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON. The output timeof PROCESSING OUT (Y10) includes the trigger delay time, marking preparation time,laser radiation time, and processing time after marking has completed.If you are not using the link function with external devices, output time of PROCESSINGOUT (Y10) is almost the same as the total duration of the trigger delay time and LASINGOUT (Y20).T5 2 to 510ms One-shot output. Set the output time on the environment setting screen.There is a small margin of error for the setting value.ME-LPGS-SM-8
