704-2 Signals and Details of I/O Terminal BlockThe I/O terminal block is loaded with the basic input/output to control the laser marker. List of signalsNo. NameX1 24V OUTInternal power 24VX2 IN COM. 1Input common 1X3 0V OUTInternal power 0VX4 REMOTE INX5 TRIGGER INX6 LASER SUPPLY INX7 RESERVESystem reservationX8 SHUTTER INX9 SHUTTER ENABLE INX10 LASER STOP 1 INX11 LASER STOP 2 IN / LASER STOP 1 INX12 OUT COM. 1Output common 1X13 RESERVESystem reservationX14 RESERVESystem reservationX15 ALARM RESET INX16 INTERLOCK 1(+)X17 INTERLOCK 1(-)X18 INTERLOCK 2(+)X19 INTERLOCK 2(-)X20 N.C.Not connectedNo. NameY1 0V OUTInternal power 0VY2 OUT COM. 1Output common 1Y3 24V OUTInternal power 24VY4 REMOTE OUTY5 READY OUTY6 LASER STANDBY OUTY7 SYSTEM STANDBY OUTY8 SHUTTER OPEN 1 OUTY9 SHUTTER OPEN 2 OUTY10 PROCESSING OUTY11 PROCESSING END OUTY12 PROCESSING FAIL OUTY13 RESERVESystem reservationY14 WARNING OUTY15 ALARM OUTY16 INTERLOCK 1 MONITORY17 INTERLOCK 1 MONITOR COM.Y18 INTERLOCK 2 MONITORY19 INTERLOCK 2 MONITOR COM.Y20 LASING OUTンㄆㄇㄆㄓㄆㄏㄆ• Use the internal power (X1, X3, Y1, Y3) as the power supply when operating the laser marker alone. Do not connectanything when using the external power supply.• Do not connect anything to RESERVE terminals and N.C. terminals.• Some terminals are already connected by the short bars with shipment. Refer to “4-5-1 Factory default wiring” (P.88).• For details on the terminal block connection, refer to “4-5 Connecting I/O Terminal Block” (P.88).ME-LPGS-SM-8
