Panasonic LP-GS Series Setup & Maintenance Manual

Also see for LP-GS Series: Serial Communication Command Guide Serial Communication Command Guide Quick reference Operation manual

Contents

Panasonic LP-GS Series Setup & Maintenance Manual Manual pdf 78 page image

784-3 Signals and Details of I/O ConnectorThe I/O connector is loaded with the input/output for data setting such as selecting a number and the input/output for thespecific functions. List of signalsNo. Name1 IN COM. 2Input common 22 SET IN3 D0 IN4 D1 IN5 D2 IN6 D3 IN7 D4 IN8 D5 IN9 D6 IN10 D7 IN11 D8 IN12 D9 IN13 D10 IN14 D11 IN15 D12 IN16 D13 IN17 D14 IN18 D15 IN19 SELECT 0 IN20 SELECT 1 IN21 SELECT 2 IN22 TIME HOLD IN23 • For LP-GS051(-L)GUIDE INGuide laser radiation input• For LP-GS052RESERVESystem reservation24 TIMING IN25 RESERVESystem reservation26No. Name27 OUT COM. 2Output common 228 SET OK OUT29 DATE GAP OUT30 COUNT END A OUT31 COUNT END B OUT32 COUNT END C OUT33 COUNT END D OUT34 CHECK OK OUT35 CHECK NG OUT36 TIMING WAIT OUT37 SCRIPTING OUT38 N.C.Not connected39 N.C.Not connected40 N.C.Not connectedンㄆㄇㄆㄓㄆㄏ㄄ㄆ• IN COM. 1, OUT COM. 1 of the I/O terminal block and IN COM. 2, OUT COM. 2 of the I/O connector are independent.If you use the I/O connector terminal, connect input common/output common of the I/O terminal block and the I/Oconnector to power supply respectively.• Do not connect anything to RESERVE terminals and N.C. terminals.• For the pin arrangement of the I/O connector, refer to “4-1 I/O Interface Specification” (P.69).ME-LPGS-SM-8