352-3 Head InstallationWARNING• Make sure that the power is turned OFF at installing. Failure to do so maycause electrical shock.• Install the product so that the laser beam path does not cross the eye height.• The laser beam path shall be enclosed with protective enclosure and makesure it is not exposed with direct light or reflected light. Carrying head part• To carry this product, wear the non-slip gloves. Hold the product with both hands. Do not hold the cables or connectorsat carrying.• Do not touch the laser emission port on the bottom of the head. It may affect the marking quality badly.• Carry this product as shown in the figure below.Laser emissionportLaser pointeremission port2-3-1 Installation directionThe head can be installed to up, down, left, and right directions. To install the product with the laser emission port facingupward or horizontally, fix both right and left sides with the bottom surface (laser emission port side) used as installationsurface, by using screw holes on the head side.ワㄐㄕㄊㄆ• When the product is installed with the laser emission port facing upward, dust generated during marking may attach tothe laser emission port, impairing marking quality and damage the product. Clean the laser emission port periodicallyaccording to the head installation conditions and environment.• Be sure to fix the bottom surface (the laser emission port side). Fixing it only on its side may cause damage on theproduct.• To install the product with the laser emission port facing upward or horizontally, fix the 3 surfaces: bottom and bothsides.ME-LPGS-SM-8
