Panasonic LP-GS Series Setup & Maintenance Manual

Also see for LP-GS Series: Serial Communication Command Guide Serial Communication Command Guide Quick reference Operation manual

Contents

Panasonic LP-GS Series Setup & Maintenance Manual Manual pdf 130 page image

1306-1-9 Timing chart Position correction - Marking (when TIMING IN signal is used)ONOFFONOFFONOFFONOFFONOFFONOFFONOFFONOFFT1T1T6T2T3T5T4TRIGGER IN (X5)PROCESSING OUT (Y10)PROCESSING END OUT (Y11)SCRIPTING OUT (No.37)TIMING IN (No.24)TIMING WAIT OUT (No.36)READY OUT (Y5)Starting location detection signalMarking triggerLASING OUT (Y20)Item Time RemarksT1 2ms or more Keep the ON status for 2ms or more.T2 ― Processing time of linkage operations with the image checker.In this case, it is the following time.• Time for location detection by image checker• Time for marking position correction by the laser markerT3 ― When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON.The output time of PROCESSING OUT includes the trigger delay time, operation time,laser radiation time and laser marker internal processing time of the linkage devices.T4 Max. 60 sec Turn on TIMING IN within 60 seconds after TIMING WAIT OUT is turned ON.If there is no input of TIMING IN within 60 seconds, an error occurs and trigger processingis terminated due to the abnormality.T5 ― Laser radiation time. This varies depending on marking contents.T6 2 to 510 ms One-shot output. Set the output time on the system settings screen.There is a small margin of error for the setting value.ME-LPGS-SM-8