93Item Time RemarksT1 Approx. 10 sec. Time for system startup. Turn ON the remote mode upon verifying SYSTEM STANDBYOUT (Y7).T2 Approx. 8 sec. Time for completion of laser pumping.• Normal: Approx. 8 sec.• Re-pumping right after turning the laser pumping OFF: Approx. 15 sec.T3 Max. 1 sec. There is a delay time of around 200ms to max. 1 second from turning ON/OFF ofSHUTTER IN (X8) to turning ON/OFF of SHUTTER OPEN 1 OUT (Y8) and SHUTTEROPEN 2 OUT (Y9).SHUTTER OPEN 1 OUT and SHUTTER OPEN 2 OUT will be output by the sameoperation, but their output timing has a margin of error.T4 ― Setup time of the laser marker to start the marking trigger processing.• In the laser pumping completed state: Total time for shutter opening (T3) and markingdata creation. It varies depending on the quantity of the setting data.• When the laser pumping is not completed: Total time for shutter opening (T3) andmarking data creation, or time for laser pumping, whichever is longer.T5 2ms or more Keep the ON status for 2ms or more.T6 ― When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON. The output timeof PROCESSING OUT (Y10) includes the trigger delay time, marking preparation time,laser radiation time, and processing time after marking has completed.If you are not using the link function with external devices, output time of PROCESSINGOUT (Y10) is almost the same as the total duration of the trigger delay time and LASINGOUT (Y20).T7 2 to 510ms One-shot output. Set the output time on the environment setting screen.There is a small margin of error for the setting value.ME-LPGS-SM-8
