124 Details of TIMING IN signalTIMING IN signal: UseTIMING IN signal is used when the laser marker operation trigger and image checker/code reader operation trigger is inputseparately, e.g. when the camera (code reader) field of view is away from the laser marker marking position.For image checking before marking For image checking after markingq wTRIGGER IN TIMING INCamera etc. Laser markerq wTRIGGER IN TIMING INCamera etc.Laser markerq Start work location detection (initial operation) q Start marking (initial operation)w Start marking w Start image checkingンㄆㄇㄆㄓㄆㄏㄆ• To control the linkage operation by TIMING IN signal, input TIMING IN signal within 60 seconds after completion of theinitial operation.• For input of TIMING IN signal, refer to “6-1-9 Timing chart” (P.130).• Input TIMING IN signal by I/O control. Any communication command cannot input TIMING IN.TIMING IN signal: Not useTIMING IN signal is not necessary when the series of operations of the laser marker and the image checker/code reader byone trigger, e.g. when the camera (code reader) field of view and the laser marker marking position are the same.For image checking before marking For image checking after markingqTRIGGER INCamera etc. Laser markerqTRIGGER INCamera etc.Laser markerq Start work location detection and start markingafter completion of location detectionq Start marking and after completion of marking,start image checkingME-LPGS-SM-8
