97Available commands are listed below.S Set a port to be monitored (port to which analyzer, etc. is connected).Press "S." The command prompt changes to "Enter port number>." Enter a portnumber you wish to configure.M Configure a port to be monitored.Press "M." The command prompt changes to "Enter port number>." Enter a portnumber you wish to monitor. (Possible to configure multiple ports)D Configure which packet should be monitored either the transmit packet or the receivepacket.Press "D." The command prompt changes to "Select port monitoringdirection(R/T/B)>." Enter "R" when monitoring the receive packet, or "T" whenmonitoring the transmit packet, or "B" when monitoring both of the receive andtransmit packet, respectively.C Start or stop monitoring.Press "C." The command prompt changes to "Enter the select(E/D)>." Enter "E" ifyou wish to start (Enable) monitoring. Enter "D" if you wish to stop (Disable)monitoring.Q Return to the previous menu.Note: VLAN tag of received VLAN ID is attached to mirror packet inTx-direction.Note: Management packet such as Ping or ARP transmitted from thisSwitching Hub cannot be captured.
