85Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.V Configure PVID settings.Press "V." The command prompt changes to "Enter port number>." Enter a portnumber you wish to configure. Then, the command prompt changes to "EnterPVID for port #>." Enter VLAN ID you wish to modify among the alreadyconfigured VLAN IDs.F Set type of receive packet.Press "F." The command prompt changes to "Enter port number>." Enter a portnumber you wish to modify. Then, the command prompt changes to "Select portacceptable frame type (A/T)>." Enter "A" to receive all the frames, or "T" to receiveonly the tagged frames, respectively.G Configure GVRP settings.Press "G." The command prompt changes to "Enter port number>." Enter a portnumber you wish to modify. Then, the command prompt changes to "Enable orDisable port GVRP status (E/D)>." Enter "E" to enable, or "D" to disable GVRP,respectively.Q Return to the previous menu.Note: This Switching Hub is possible to assign multiple VLANs to one port.When new VLAN was configured, it belongs to both VLAN to whichit has belonged and the new VLAN. So, when you divide the domain,make sure to delete it from a VLAN to which it has belonged.
