55Available commands are listed below.S Set a status of Syslog Transmission.Press "S." The command prompt changes to "Enter manager entry number>." EnterNo. you wish to set. Then, the command prompt changes to "Enable or DisableServer (E/D)>." Enter "E" to enable, or "D" to disable the server.F Set Facility.Press "F." The command prompt changes to "Enter manager entry number>." EnterNo. you wish to set. Then, the command prompt changes to "Enter Server Facility>."Enter a value of 0 to 7 (Local0 to Local7).I Set an IP address of Syslog server.Press "I." The command prompt changes to "Enter manager entry number>." EnterNo. you wish to set. Then, the command prompt changes to "Enter IP address formanager>." Enter an IP address of Syslog server.Y Set information that is added to a system log to be transmitted.Press "Y." The command prompt changes to "Enter manager entry number>." EnterNo. you wish to set. Then, the command prompt changes to "Enter IncludeInformation>." Enter "S" when adding a SysName of this Switching Hub, or "I" whenadding IP address, or "N" when not adding IP address.C Delete setting information of Syslog Transmission.Press "C." The command prompt changes to "Enter manager entry number>." EnterNo. you wish to delete. Then, the command prompt changes to "Clear Syslog Serverinformation>." Enter "Y" when deleting, or "N" when not deleting the severinformation.Q Return to the previous menu.
