49Available commands are listed below.C Configure the idle timeout settings for automatically terminating aconsole-connected session if no input is made.Press "C." The command prompt changes to "Enter console idle timeout>." Enter avalue from 0 to 60 (minutes). Entering "0" disables the automatic termination.T Configure the idle timeout settings for automatically terminating a Telnet-connectedsession if no input is made.Press "T." The command prompt changes to "Enter telnet idle timeout>." Enter avalue from 1 to 60 (minutes).N Edit the login username.Press "N." The command prompt changes to "Enter current password>." Enter thecurrent password. After entering the correct password, the command promptchanges to "Enter new name>." Enter a new username in 12 characters.P Edit the login password.Press "P." The command prompt changes to "Enter old password>." Enter thecurrent password. After entering the correct password, the command promptchanges to "Enter new password>." Enter a new password in 12 characters. Afterentering the password, the command prompt changes to "Retype newpassword>" for confirmation. Enter the new password again.L Configure the Telnet access settings.Press "L." The command prompt changes to "Enable or Disable telnetserver(E/D)>."Enter "E" to enable the access. Enter "D" to disable the access.S Configure the SNMP access settings.Press "S." The command prompt changes to "Enable or Disable SNMPAgent(E/D)>."Enter "E" to enable the access. Enter "D" to disable the access.W Configure the web access settings.Press "W." The command prompt changes to "Enable or Disable webserver(E/D)>."Enter "E" to enable the access. Enter "D" to disable the access.Y Configure the settings for sending system logs to the Syslog server.Press "Y." The command prompt changes to "Enable or Disable SyslogTransmission (E/D)>."Enter "E" to enable the Syslog transmission to the Syslog server. Enter "D" todisable the Syslog transmission to the Syslog server.R Configure the access settings to access the RADIUS server. The RADIUS used in theIEEE802.1X port-based authentication.Press "R" to move to the RADIUS Configuration page. For configuration details,refer to the next section (4.6.5.a).G Configure the settings for sending system logs to the Syslog server.Press "G" to move to the Syslog Transmission Configuration page. Forconfiguration details, refer to the next section (4.6.6.b).Q Return to the previous menu.
