46Available commands are listed below.N Show the next page.Press "N." The screen displays the next port.P Show the previous page.Pressing "P" displays previous port.A A name can be assigned to each port.Press "A." The command prompt changes to "Select port number to be changed>."Enter a port number you wish to configure. To configure all ports at once, enter"0" as the port number. Then, the command prompt changes to "Enter port namestring>." Enter a name you wish to assign. As the change is applied, the display onthe upper screen is updated automatically.J Enable/disable the jumbo frame forwarding function.Press "J." The command prompt changes to "Select port number to be changed>."Enter a port number you wish to configure. To configure all ports at once, enter"0" as the port number. Then, the command prompt changes to "Enable orDisable jumbo status for port # (E/D)>." Press "E" to enable the function. Press "D"to disable it. As the change is applied, the display on the upper screen is updatedautomatically.E Enable/disable the EAP packet forwarding function.Press "E." The command prompt changes to "Enter port number>." Enter a portnumber you wish to configure. To configure all ports at once, enter "0" as the portnumber. Then, the command prompt changes to "Enable or Disable EAP forwardfor port # (E/D)>." Press "E" to enable the function. Press "D" to disable it. As thechange is applied, the display on the upper screen is updated automatically.Q Return to the previous menu.Note: The screen displays the port status; however, the status is notautomatically updated. To display the latest status, press any key.
