43Available commands are listed below.N Show the next page.Press "N." The screen displays the next port.P Show the previous page.Pressing "P" displays the previous port.A Enable/disable a port.Press "A." The command prompt changes to "Select port number to be changed>."Enter a port number you wish to configure. To configure all ports at once, enter"0" as the port number. Then, the command prompt changes to "Enable orDisable port # (E/D)>." Press "E" to enable the port. Press "D" to disable it. As thechange is applied, the display on the upper screen is updated automatically.M Configure the speed and full-duplex/half-duplex settings for each port.Press "M." The command prompt changes to "Enter port number>." Enter a portnumber you wish to configure. To configure all ports at once, enter "0" as the portnumber. Then, the command prompt changes to "Enter mode for port # (A/N)>."Press "A" to enable the auto negotiation mode. Press "N" to disable it. If "N" isselected, the command prompt changes to "Enter speed for port #(10/100)>."Select a desired communication speed. Upon setting, the command promptchanges to "Enter duplex for port #(F/H)>." Select "F" for full-duplex, or "H" forhalf-duplex. As the change is applied, the display on the upper screen is updatedautomatically.Mode: A: Enable the auto negotiation mode.N: Disable the auto negotiation mode (fixing the speed at Giga isnot supported).Speed: 10: Set at 10 Mbps.100: Set at 100 Mbps.Duplex: F: Set at full-duplex.H: Set at half-duplex.F Enable/disable the flow control.Press "F." The command prompt changes to "Select port number to be changed>."Enter a port number you wish to configure. To configure all ports at once, enter"0" as the port number. Then, the command prompt changes to "Enable orDisable flow control for port # (E/D)>." Press "E" to enable the function. Press "D"to disable it. As the change is applied, the display on the upper screen is updatedautomatically.S Enable/disable the AUTO-MDI function.Press "S." The command prompt changes to "Enter port number>." Enter a portnumber (from 1 to 24) you wish to configure. To configure all ports at once, enter"0" as the port number. Then, the command prompt changes to "Enable orDisable Auto-MDl for port # (E/D)>." Press "E" to enable the function. Press "D" todisable it. As the change is applied, the display on the upper screen is updatedautomatically.Q Return to the previous menu.Note: The screen displays the port status; however, the status is notautomatically updated. To display the latest status, press any key.
