197Available commands are listed below.N Set the domain name.Press "N." The command prompt changes to "Enter RRP Domain Name>." Enter aname of the domain to be configured in 25 characters or less.T Set the node role.Press "N." The command prompt changes to "Enter RRP Node Type (M/T) >." Press"M" to set the domain for a master node. Press "T" to set the domain for a transitnode.P Set the primary port.Press "P." The command prompt changes to "Enter RRP Primary Port >." Enter theport number (1-10) you wish to set as a primary port.S Set the secondary port.Press "S." The command prompt changes to "Enter RRP Secondary Port >." Enter theport number (1-10) you wish to set as a secondary port.O Set the polling interval.Press "O." The command prompt changes to "Enter RRP Polling Interval>." Enter avalue between 1 and 2 (seconds) as the polling interval.F Set the timeout for polling.Press "F." The command prompt changes to "Enter RRP Fail Period>." Enter a valuebetween 2 and 5 (seconds) as the timeout for polling.S Set the control VLAN ID.Press "S." The command prompt changes to "Enter Control VLAN ID >." Enter theVLAN ID (2-4094) you wish to set as a control VLAN. When entering two or moreport numbers, separate them with a comma without a space, or use a hyphen forconsecutive numbers.D Set the data VLAN ID.Press "D." The command prompt changes to "Enter Data VLAN ID >." Enter the VLANID (1-4094) you wish to set as a data VLAN. When entering two or more VLAN IDs,separate them with a comma without a space, or use a hyphen for consecutivenumbers.A Set a domain.Press "A" to apply your settings.Q Return to the previous menu.Note: If you press "Q" (Quit) after setting a domain, your settings will not beapplied. Be sure to press "A" (Apply) to apply your domain settingmodifications.
