1734.7.9.f.1. EAP-Request Port Configuration MenuOn the EAP-Request Configuration screen, pressing "E" opens theEAP-Request Port Configuration Menu as shown in Fig. 4-7-51. On thisscreen, you can configure EAP Request sending for each port in MAC-basedaccess control mode.Fig. 4-7-51 EAP-Request Port ConfigurationScreen DescriptionEAP-RequestIntervalDisplays the EAP-Request sending interval.Port Displays the port number.EAP-Request Displays the EAP Request sending status.Enabled EAP Request is periodically sent.Disabled EAP Request is not sent. (Factory default setting)Available commands are listed below.N Show the next page.Press "N" to go to the next page.P Show the previous page.Press "P" to go to the previous page.E Set the EAP Request sending interval.Press "E." The command prompt changes to "Enter new interval>." Enter a value withinthe range specified in the black band at the bottom of the screen.S Change the EAP request mode.PN23249K/PN23249A Local Management System802.1x Access Control Configuration -> EAP-Request Port ConfigurationEAP-Request Interval: 5 Sec.Port EAP-Request------ ------------1 Disabled2 Disabled3 Disabled4 Disabled5 Disabled6 Disabled7 Disabled8 Disabled-------------------------------- -----------------------------------[N]ext Page [E]AP-Request Interval[P]revious Page [S]et EAP-Request Mode[Q]uit to previous menuCommand>Enter the character in square brackets to select option
