168Available commands are listed below.S Change the target port of the counter value display.Press "S." The command prompt changes to "Select Port number>." Enter theport number you wish to display.N Show the values of the next port.Press "N." The screen displays the counter values of the next port. After youreach Port 26, you cannot go back to Port 1 by pressing "N."P Show the values of the previous port.Press "P." The screen displays the counter values of the previous port. Thiscommand is not available on the Port 1 screen.R Change the counter values with those accumulated after resetting the counters.Press "R." The counter values are immediately changed with thoseaccumulated after resetting the counters. The time display field on the upperright corner of the screen changes to Elapsed Time Since System Reset.F Set the counter refresh mode.Press "F." The comment line displays "1 for start to refresh, 2 for set refreshrate." Enter 1 to cancel refresh. The refresh interval field displays "STOP," andthe display is not refreshed. Enter 2 to change the refresh interval. Thecommand prompt changes to "Input refresh time>." Enter an integer between5 and 600 (seconds).Q Return to the previous menu.On this screen, you can display two types of counter values: Valuesaccumulated after booting this Switching Hub or rebooting it bypower-off/resetting (Fig. 4-7-48), and values accumulated after resettingthe counters using a command (Fig. 4-7-49). The values accumulated afterbooting the Switching Hub are retained even after you reset the countervalues using a command.PN23249K/PN23249A Local Management System802.1x Access Control Configuration -> Statistics MenuPort: 1 Refresh: 300 Sec. Elapsed Time Since System Reset: 000:00:00:00 TxReqId 0TxReq 0TxTotal 0RxStart 0RxLogoff 0RxRespId 0RxResp 0RxInvalid 0RxLenError 0RxTotal 0RxVersion 0LastRxSrcMac 00:00:00:00:00:00-------------------------------- -----------------------------------[N]ext [P]revious [S]elect Port Re[f]resh Mode Since [R]eset [Q]uitCommand>Enter the character in square brackets to select option
