158Available commands are listed below.F Set Default VLAN ID.Press "F." The command prompt changes to "Enter default VLAN ID>." Enter aninteger between 1 and 4094. Enter 0 to disable the Default VLAN function.T Set the interval time to reattempt of authentication.Press "T." The command prompt changes to "Enter Transmission Period>." Enter aninteger between 1 and 65535 (seconds).U Set the period time to wait before reattempting a failed authentication.Press "U." The command prompt changes to "Enter Quiet Period>." Enter aninteger between 1 and 65535 (seconds).X Set the maximum number of reattempts of authentication.Press "X." The command prompt changes to "Enter Max request count>." Enter themaximum number of reattempts with an integer between 1 and 10.O Set timeout for the authentication server.Press "O." The command prompt changes to "Enter Server Timeout>." Enter aninteger between 1 and 65535 (seconds).L Set the timeout for the clientPress "L." The command prompt changes to "Enter Supplicant Timeout value>."Enter an integer between 1 and 65535 (seconds).S Set the Guest Access application conditions.Press "S." The command prompt changes to "Select the guest access mode (T/B/A)>." Press "T" to select Supplicant Timeout, "A" to select Auth Fail, or "B" for both.G Specify a VLAN to be assigned when a terminal that failed authentication or that doesnot have a supplicant is connected.Press "G." The command prompt changes to "Enter guest VLAN ID >." Enter aninteger between 1 and 4094. Enter 0 to disable the Guest Access function.Y Enable/disable the dynamic VLAN function.Press "Y." The command prompt changes to "Enable or Disable dynamic VLANstatus? (E/D) >." Press "E" to enable the dynamic VLAN function. Press "D" todisable it.E Set the periodic re-authentication time interval.Press "E." The command prompt changes to "Enter re-authentication Period>."Enter an integer between 1 and 65535 (seconds).A Enable/disable periodic re-authentication.Press "A." The command prompt changes to "Enable or Disable re-authentication?(E/D)>." Press "E" to enable re-authentication. Press "D" to disable it.Z Initialize the authentication status.Press "Z." The command prompt changes to "Would you initializeauthenticator?(Y/N)>." To initialize it, press "Y." Otherwise, press "N."R Initialize the re-authentication status.Press "R." The command prompt changes to "Would you want to initializere-authenticator?(Y/N)>." To initialize it, press "Y." Otherwise, press "N."H Not available for Port Based modeI Not available for Port Based modeQ Return to the previous menu.Note: Our switches assign a VLAN ID in reference to the value of Attribute81 (Tunnel Private Group Id) included in RADIUS packets from theRADIUS server.
