105Screen DescriptionBPDU GuardRecoveryDisplays enable/disable of auto-recovery of BPDU guard.The factory default setting is Disabled.Enabled Auto-recovery is enabledDisabled Auto-recovery is disabledBPDU GuardRecoveryTimerDisplays the time to auto-recovery. The factory default setting is 300 sec.Port Displays the port number.Trunk Displays the group number (key) of the trunk if trunking is set.Link Displays the state of link.UP Link is established normally.DOWN Link is not established.State Displays the present state of port.Forwarding Displays the state of normal communications based on thecalculation result.Learning Displays the state under calculation based on information.Discarding Displays the state that calculation is not carried out.Role Displays the role of port in the spanning tree.Designated Operating as a designated portRoot Operating as a root portAlternate Operating as an alternate portBackup Operating as a backup portDisabled STP is not working.Pri. Displays priority of each port in the Switching Hub. Higher number hashigher priority. For all ports, the factory default setting is set to 128. (Avalue is a multiple of 16.)Path Cost Displays the cost of each port.Ports 1-24 are set to 200000 (A) and Ports 25-26 are set to 20000 (A) atfactory defaut setting.STP Status Displays enable/disable of the spanning tree of each port.Enabled The spanning tree is enabled.Disabled The spanning tree is disabled.Guard Displays enable/disable of the BPDU guard of each port.'Disabled' is the factory default setting.Enabled The BPDU guard is enabled.Disabled The BPDU guard is disabled.
