170Screen DescriptionPort Displays the port number.Refresh Displays the refresh interval.Elapsed TimeSince ResetDisplays the time elapsed since resetting of the counters.Counter Name Displays each counter name.Total Displays values accumulated in the counters.Available commands are listed below.S Change the target port of the counter value display.Press "S." The command prompt changes to "Select Port number>." Enter theport number you wish to display.N Show the values of the next port.Press "N." The screen displays the counter values of the next port. After youreach Port 26, you cannot go back to Port 1 by pressing "N."P Show the values of the previous port.Press "P." The screen displays the counter values of the previous port. Thiscommand is not available on the Port 1 screen.U Change the counter values with those accumulated since the boot.Press "U." The counter values accumulated after resetting the counters areimmediately changed with those accumulated after the system boot.R Change the counter values with those accumulated after resetting the counters.Press "R." All counter values are immediately reset to 0 and displayed.F Set the counter refresh mode.Press "F." The comment line displays "1 for start to refresh, 2 for set refreshrate." Enter 1 to cancel refresh. The refresh interval field displays "STOP," andthe display is not refreshed. Enter 2 to change the refresh interval. Thecommand prompt changes to "Input refresh time>." Enter an integer between5 and 600 (seconds).Q Return to the previous menu.
