45 Connection typeWith one of the following method you can connect a PC with Laser Marker NAVI smart installed and the laser marker.qweRear of controller Front of headPCンㄆㄇㄆㄓㄆㄏㄆ• One PC can be connected with multiple laser markers. However, only one laser marker can be connected with LaserMarker NAVI smart online. In this case, switch the online connected model on the Laser Marker NAVI smart and performsetting and control for each laser marker. It is not allowed to set and control multiple laser markers simultaneously fromone PC.• For the procedure to connect the laser marker and Laser Marker NAVI smart online, refer to “3-3-3 How to establishonline connection” (P.56).q USB connectionConnect the attached USB cable to the USB port B on the controller.Multiple laser markers can be connected via a USB hub, etc.ワㄐㄕㄊㄆ• Do not disconnect the USB cable when the laser marker is connected online.w Ethernet connectionConnect the LAN cable to the Ethernet port on the controller.For details of specifications and connection of the Ethernet port, refer to “5-3 Ethernet” (P.112).ンㄆㄇㄆㄓㄆㄏㄆ• For Ethernet online connection, connect the laser marker and PC via USB cable in advance and configure the lasermarker communication settings. Refer to “Setting procedure for Ethernet/Bluetooth online connection” (P.57).• The Ethernet port can be connected with the following devices simultaneously via a HUB or a router.• PC configuration software• External device for communication command control (PLC and PC for control)• Specific image checkerME-LPGS-SM-8
