Panasonic LP-GS Series Setup & Maintenance Manual

Also see for LP-GS Series: Serial Communication Command Guide Serial Communication Command Guide Quick reference Operation manual

Contents

Panasonic LP-GS Series Setup & Maintenance Manual Manual pdf 43 page image

434. Connect the three wires to the terminals.The signs of “L (black)”, “N (white)” and “PE (GND) (yellow/green)” show inthe cables. Connect each cable to the appropriate terminal.Screw size: M4Tightening torque: 1.2N·mワㄐㄕㄊ㄄ㄆ• Connect the attached AC power cable (AC power supply cable).• Attached AC power cable varies depending on each model. Please select acable compliant with the standards in the country or region where it is used.5. Attach the resin cover to the terminal and screw the terminalcover.Screw size: M3Tightening torque: 0.5N·m6. Fix the AC power cable with the clamp.Screw size: M4Tightening torque: 1.0N·mワㄐㄕㄊ㄄ㄆ• Locate the AC power cable beside the fan. Locating it in front of the fanmay impair the air-cooling performance, leading to the device failure.7. Make sure that the cables and connectors other than the power supply are connected and thenconnect the AC power cable to the AC power supply.Power voltage: 90V to 132V AC or 180V to 264V AC (including ±10% voltage fluctuations; automatic switching)ワㄐㄕㄊ㄄ㄆ• The earth terminal of the AC power cable must be permanently grounded.• Set each connecting cable away from the device that generates high voltage, power line, and large switching surge asfar as possible. If there may be any noise effect on the power supply, use the noise cut-off transformer./13(L NME-LPGS-SM-8