133 Position correction - Marking - Image checking (when TIMING IN signal is not used)ONOFFONOFFONOFFONOFFONOFFONOFFONOFFT1T6T6T2T4T5T3*1TRIGGER IN (X5)PROCESSING OUT (Y10)CHECK OK OUT (No.34)CHECK NG OUT (No.35)PROCESSING END OUT (Y11)SCRIPTING OUT (No.37)READY OUT (Y5)Starting a series of interfaced operations signalorLASING OUT (Y20)*1: CHECK OK OUT (No.34) / CHECK NG OUT (No.35) outputs before PROCESSING OUT (Y10) is turned OFF.Item Time RemarksT1 2ms or more Keep the ON status for 2ms or more.T2 ― When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON.The output time of PROCESSING OUT includes the trigger delay time, operation time,laser radiation time and laser marker internal processing time of the linkage devices.T3 ― Processing time of linkage operations with the image checker.In this case, it is the following time.• Time for location detection by image checker• Time for marking position correction by the laser markerT4 ― Laser radiation time. The time varies depending on marking contents.T5 ― Processing time of linkage operations with the image checker.In this case, it is the following time.• Time for reading by the image checker• Time for transferring the checkup results from the image checker to the laser markerT6 2 to 510 ms One-shot output. Set the output time on the system settings screen.There is a small margin of error for the setting value.ME-LPGS-SM-8
