2- 43 Change the height of the printheadTOPChapter 3Printing by ObjectiveChapter 4MaintenanceChapter 5Using the Printerin a NetworkEnvironmentChapter 6TroubleshootingChapter 7Operating theFunction MenuIndexContentsChapter 2Using Various MediaChapter 1Basic UseChange the height of the printheadIt is possible to achieve the higher print quality by adjustingthe height of the printhead. Follow the procedure below tooperate.Use the following procedure.Change the height of the printhead. (→ P.2-43)Set a cut sheet of the type you intend to use.(→ P.2-28, P.2-38)Aligning the Printhead. (→ P.4-41)Printing. (→ P.1-38)After completing the special print job, return theprinthead height to its original setting and re-align theprinthead. (→ P.4-41)Importantz If the printhead height was changed, make sure toadjust the print status. If adjustment is not performed,optimal printing results cannot be obtained.z When printing on paper-base media (ex: CoatedPaper, Plain Paper) or any type of media that wrinkleseasily, never print with the printhead lower than thebest height for each media. This could also damagethe printer.Notez Press the Information button to check the currentheight of the printhead using Head Heigh, and theoptimum height for the paper type selected.Changing Printhead Height1 Press the Online button to display MAINMENU.2 Press [] (or []) to select Chng HeadHght then press [].3 Press [] or [] to select Yes, then pressOK button.The carrige moves to the center when you seeCarriage Moving.Chng Head Hght=YesDataInformation PowerMessageOnlineCleaning(3 sec.)Stop/Eject(1 sec.)MAIN MENUHead CleaningDataInformation PowerOfflineMenuMessageMAIN MENUChng Head HghtOnlineCleaning(3 sec.)Stop/Eject(1 sec.)
