2- 28 Printing with Rolls MediaTOPChapter 3Printing by ObjectiveChapter 4MaintenanceChapter 5Using the Printerin a NetworkEnvironmentChapter 6TroubleshootingChapter 7Operating theFunction MenuIndexContentsChapter 2Using Various MediaChapter 1Basic UsePrinting with Rolls MediaLoading Roll MediaThis is the general procedure for loading roll media.After printing remove the completed printout and anymedia loaded on the platen. (→ P.2-35, P.2-42)On the operation panel, select the roll media source.(→ P.2-28)Load the roll media in the roll holder slot. (→ P.2-29)Load the roll media on the platen. (→ P.2-32)On the printer operation panel, select the media type.(→ P.2-32)Adjust the amount of media feed. (→ P.4-43)Start the print job from the computer. (→ P.1-38)Importantz Make sure to turn off the power supply to the printerbefore loading the roll media. Further, if the loadedmedia differs from the media type setting, the printquality may be reduced.z The roll media remaining detection function cannot beused for Tracing Paper or Translucent Matte Film.When using a Tracing Paper roll or Translucent MatteFilm roll, switch off the roll media remaining detectionfunction before loading the roll. Selecting the Paper SourceWhen printing on roll media, select roll media as thepaper source using the operation panel.1 Press and hold the Paper Source button for1 second or more to light the Roll Medialamp.When cut paper is loaded, the printer will displayRemove CutSheet?.If you have loaded another roll, press and hold theStop/Eject button for 1 second or more to displayRemove RllMedia?.2 If the cut sheet or roll media is set to theprinter, press the OK button.Remove the cut sheets or roll media.(→ P.2-35, P.2-42)Remove CutSheet?Press OK/StopDataInformation PowerOfflineMenuMessageOffline Feed PaperOnlineCleaning(3 sec.)Stop/Eject(1 sec.)
